I have an original Millipede ball with original bearings, which are the best spinning ones I've ever felt, and have not been able to find ones as good as those yet. The best ones I've found so far are the ones Arcadeshop sells, but I don't know where he gets them. I've been looking into new replacement bearings, and have tried several types of Chinese ones from places like ebay, including ceramic ones, with mixed results (and have also tried flushing out the factory lube and replacing with Liquid Bearings, etc). This works, but if the bearings were rusted, they end up pitted, and will spin ok, but are noisy. Spinner acceleration table can be customized by editing the map in computesteps2() function. You can use Liquid Bearings as well, but I find the silicone just lasts longer before you need to re-lube, and there are only two points to lube, so it's not that hard to apply with a toothpick (as opposed to the Arkanoid spinners, which have many points).įor trakballs, I've tried rejuvenating old rusty bearings, soaking them, spinning them in a drill, flushing them out, drying, then re-lubing with Liquid Bearings. The aim of this project is the development of an stm32-based arcade spinner to be used, for example, in Arkanoid gameplay. Correctly-designed flywheels with mass concentrated at the. Arkanoid, and many others but I especially use it for super sprint racing. Can also be used as a spinner with the addition of one of two sizes of fly-weight to provide inertia giving long spin-times of up to 20 seconds. The 2 diameter orb in the center of the spinner creates a beautiful visual effect. I use 100% silicone grease on Tempest spinners, which is lighter and more slippery, and I prefer the feel much better (as I'm a regular Tempest player). Features: Two modes of operation: Can be used as a lightweight Super High Resolution Low-Inertia Trackwheel control as used in 'Arkanoid'. Can be used as a lightweight Super High Resolution Low-Inertia Trackwheel control as used in Arkanoid Can also be used as a spinner with the addition of. But it made the spinner spin down too quickly. I know on Tempest spinners I've tried Nyogel (which was the recommended lube from Atari), which I found to be too thick, as it's a dampening grease, and is meant to be sticky. I have an original arkanoid board with harness and spinner. I can't speak for sewing machine oil, but the lube can make a difference. how do I wire the control panel from the board in an arkanoid I need to know how to properly get the power to the spinner so that I can determine if mine is working or if I need to order a new one.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |